Hirschmann qSCALE i2 - Page 116

Appendix
© 2016 Hirschmann Automation and Control GmbH · Mobile Machine Control Solutions · www.beldensolutions.com 116/161
qSCALE i2 Cranes (Tool Version 3.0.34) Service Manual / Issue B / 11-2017 / ac.
Error
Code
Description
Cause
Notice/Solution
113E
broken wire
Sensor Error: IO-
MinTW1
Faulty Rope-end switch
or input module is
defective
Check the CAN connections and wiring, the
sensor calibration, and the CAN configura-
tion. Invalid sensor swap
123E
circuit ground
133E
circuit battery
143E
module error
153E
output deactivated
163E
error +UB
173E
data error / CAN error
183E
timeout / CAN timeout
193E
safety error
1A3E
parameter error
1B3E
unspecified error
1C3E
missing adjustment
113F
broken wire
Sensor Error: IO-
MinTW2
Faulty Rope-end switch
or input module is
defective
Check the CAN connections and wiring, the
sensor calibration, and the CAN configura-
tion. Invalid sensor swap
123F
circuit ground
133F
circuit battery
143F
module error
153F
output deactivated
163F
error +UB
173F
data error / CAN error
183F
timeout / CAN timeout
193F
safety error
1A3F
parameter error
1B3F
unspecified error
1C3F
missing adjustment
1140
broken wire
Sensor Error: IOSetup1
Faulty Setup switch or
input module is defective
Check the CAN connections and wiring, the
sensor calibration, and the CAN configura-
tion. Invalid sensor swap
1240
circuit ground
1340
circuit battery
1440
module error
1540
output deactivated
1640
error +UB
1740
data error / CAN error
1840
timeout / CAN timeout
1940
safety error
1A40
parameter error
1B40
unspecified error
1C40
missing adjustment