Hirschmann qSCALE i2 - Page 148

Appendix
© 2016 Hirschmann Automation and Control GmbH · Mobile Machine Control Solutions · www.beldensolutions.com 148/161
qSCALE i2 Cranes (Tool Version 3.0.34) Service Manual / Issue B / 11-2017 / ac.
Error
Code
Description
Cause
Notice/Solution
11A9
broken wire
Capacity
Error on value
Check the sensors and actuators. Data
Programming does not cover the operating
state. Consult Customer Service if the error
occurs again
12A9
circuit ground
13A9
circuit battery
14A9
module error
15A9
output deactivated
16A9
error +UB
17A9
data error / CAN error
18A9
timeout / CAN timeout
19A9
safety error
1AA9
parameter error
1BA9
unspecified error
1CA9
missing adjustment
11AA
broken wire
Load
Error on value
Check the sensors and actuators. Data
Programming does not cover the operating
state. Consult Customer Service if the error
occurs again
12AA
circuit ground
13AA
circuit battery
14AA
module error
15AA
output deactivated
16AA
error +UB
17AA
data error / CAN error
18AA
timeout / CAN timeout
19AA
safety error
1AAA
parameter error
1BAA
unspecified error
1CAA
missing adjustment
11AB
broken wire
Wind Speed
Error on value
Check the sensors and actuators. Data
Programming does not cover the operating
state. Consult Customer Service if the error
occurs again
12AB
circuit ground
13AB
circuit battery
14AB
module error
15AB
output deactivated
16AB
error +UB
17AB
data error / CAN error
18AB
timeout / CAN timeout
19AB
safety error
1AAB
parameter error
1BAB
unspecified error
1CAB
missing adjustment