Hirschmann qSCALE i2 - Page 99

Appendix
© 2016 Hirschmann Automation and Control GmbH · Mobile Machine Control Solutions · www.beldensolutions.com 99/161
qSCALE i2 Cranes (Tool Version 3.0.34) Service Manual / Issue B / 11-2017 / ac.
Error
Code
Description
Cause
Notice/Solution
110B
broken wire
Sensor Error: IORod3
Faulty pressure or input
module is defective
Check the CAN connections and wiring, the
sensor calibration, and the CAN configura-
tion. Invalid sensor swap
120B
circuit ground
130B
circuit battery
140B
module error
150B
output deactivated
160B
error +UB
170B
data error / CAN error
180B
timeout / CAN timeout
190B
safety error
1A0B
parameter error
1B0B
unspecified error
1C0B
missing adjustment
110C
broken wire
Sensor Error:
IOLength4
Length sensor failure or
input module is defective
Check the CAN connections and wiring, the
sensor calibration, and the CAN configura-
tion. Invalid sensor swap
120C
circuit ground
130C
circuit battery
140C
module error
150C
output deactivated
160C
error +UB
170C
data error / CAN error
180C
timeout / CAN timeout
190C
safety error
1A0C
parameter error
1B0C
unspecified error
1C0C
missing adjustment
110D
broken wire
Sensor Error: IOAngle4
Angle fault or input
module is defective
Check the CAN connections and wiring, the
sensor calibration, and the CAN configura-
tion. Invalid sensor swap
120D
circuit ground
130D
circuit battery
140D
module error
150D
output deactivated
160D
error +UB
170D
data error / CAN error
180D
timeout / CAN timeout
190D
safety error
1A0D
parameter error
1B0D
unspecified error
1C0D
missing adjustment