WIKA Mobile Control LP
1540 Orchard Drive
Chambersburg, PA 17201
qSCALE maestro (PLC v01.00.00) Service Manual / Issue E (HMI v1.0.0) 04/2018 / rbm.
Service : (717) 217-2250
Parts / Sales : (717) 217-2269
www.wika-mc.com
44
/76
HIRSCHMANN MCS
6.2 Initial System Inspection
Check all CAN cables for breaks, cuts or damage of any
kind.
Check connections at sensors and at the CAN Junction Box
Check for water across the terminals in the CAN bus or
inside the Junction Box
Cycle System Power. A Waiting for Connection error can be
caused by cycling the system power off and on too quickly.
There must be a minimum of 10 seconds between powering
off and back on again.
Low system voltage can cause CAN bus errors.
Off
… Wait 10 Seconds…
On
To Next Page
Loading...
