Hirschmann qSCALE maestro - Troubleshooting Sensors With Display; Readings of CAN Bus Sensors

WIKA Mobile Control LP
1540 Orchard Drive
Chambersburg, PA 17201
qSCALE maestro (PLC v01.00.00) Service Manual / Issue E (HMI v1.0.0) 04/2018 / rbm.
Service : (717) 217-2250
Parts / Sales : (717) 217-2269
www.wika-mc.com
58 /76
HIRSCHMANN MCS
6.11 Troubleshooting Sensors With Display
The status of all inputs and outputs of the system can be checked using several screen displays on the
console.
6.11.1 Readings of CAN Bus Sensors
To determine whether there is a problem with a sensor, the system has a built in “Analog Input” screen
to make trouble-shooting easier. This is the place to start if you suspect a problem with a sensor.
  
HOME SETTINGS MACHINE
INFO
ANALOG
INPUTS
The Analog Inputs screen shows the current readings
from each Analog Sensor. The raw value is displayed
on the left and the measured value is displayed on the
right.
If any problems are detected with a sensor an error icon
will appear in the box to the right:
Short to Ground Open Circuit Short to Battery
Not Calibrated Deactivated Response Timeout
No Signal From Sensor