When you want to stop the printing in midstream, the printing can be interrupted by
selecting Abort.
・When selecting “For test”, the printing conditions are automatically set as described
below.
Number of line : one line
Character size : 12×16 dots
Inter-char. Space : 1
Character height : 99
Character width : 5
Ink drop use : f/3
Product speed matching : Time based
The content of printing is as described below.
█ █123ABC
Printed phase Printed phase which is set at present
(16 phases in total (a phase determined to be most suitable)
from 0 to f) (any one from 0 to f)
・When selecting “Data to be displayed”, a printing is performed under the printing
conditions/printing contents set at present.
4 Determination method of test.
Observing the print phases of from phase 0 to phase 15 (f), when a printing is not
normally performed in the range of one or more phases in the vicinity of the “print
phase which is set at present”, clogging of nozzles (including a filter) or
deterioration of ink is considered and therefore, perform the washing of nozzles,
the change of filters and the change of ink.
2-11
To Next Page
Loading...
