Hitachi P-AP56NAM - Electrical Wiring

c. While pushing the wiring into the corner pocket, insert
the xing hooks (2 portions) at
A
to the square hole of
the air panel, and push the receiver kit toward the arrow
direction (
A
). Then, insert the xing hook (1 portion) at
B
to the square hole of the air panel.
? NOTE
Catchsecurelythexinghooksofthereceiverkittotheairpanel.
Ifnot,thexinghookswillbedamaged.
A
A
B
9.4 ELECTRICAL WIRING OF AIR PANEL P-AP56NAMR
Open the electrical box cover at the indoor unit. Connect the connecting cable to the terminal A and B in the electrical box. (No
polarity with terminals A and B)
ON
12
Indoor unit
Electrical box
Wire clamp
Cable
Air panel
This receiver kit can be installed to any four corners of the air panel. In the case of installing it to far corner from the electrical box,
run through the wiring for the receiver kit on the xing plate of the unit between the receiver kit and the electrical box of the unit as
shown.
After running the connecting cable, clamp the extra length of the connecting cable by the plastic band and store it at inside the
ceiling.
Example: installing receiver kit to far corner from electrical box
Indoor unit wiring connection Wire clamp
Connecting cable
Fixing
plate
? NOTE
Ifinstallingthereceiverkitneartheelectricalbox,anextracableshallbindupbythewireclamp.
6 After the installation work for receiver kit is completed, attach the corner pocket covers (3 portions).
AIR PANEL P-AP56NAMR
PMML0570 rev.0 - 01/2021
17
EN