Hitachi P-AP56NAM - Page 28

Optional function
Dip switch setting (DSW1)
Details
1 2 3 4 5 6
Main/Sub Setting
O X X X X X
Change main (OFF setting)/ sub (ON setting)
remote control switches for 2 remote control
system.
Identifying of Indoor Unit
X (*) X X (*) X
(*): By ON/OFF combination of DSW1-2 and DSW1-
5, set the A to D mode (identifying of indoor unit)
of the wireless controller.
Invalidity of Emergency Operation X X X O X X The switches for emergency operation are invalid.
O: ON / X: OFF
? NOTE
Payattentiontothefollowingsettingswhenthefunctionforreceiverkitisselectedfromtheremotecontrolswitchorthecentralizedcontroller.
• Thecoolinglowerlimitforsettingtemperatureandtheheatingupperlimitforsettingtemperaturearenotavailable.Thesettingisavailablebeyond
theupperandlowerlimitforsettingtemperaturefromthewirelessremotecontrolswitch.
• Theoptionalfunctionsetting“FixingofSettingTemperature”isnotavailable.Whentheoperationmodeischangedfromthewirelessremotecontrol
switch,theindicatedtemperatureontheremotecontrolswitchbecomessettemperature.
9.10 SENDING COMMANDS FROM WIRELESS REMOTE CONTROL SWITCH
• The operation commands are sent by pressing the required
operation switch by facing the transmitter of the wireless
remote control switch toward the receiver of the indoor unit.
• When commands are sent from the wireless remote control
switch, it should face vertically and be as close as possible
to the receiver kit. The capable distance for transmitting will
get shorter in case that the transmitting angle is not vertical
to the receiver or an electronic type light is used in the room,
etc.
• The wireless remote control switch has directivity against
the receiver. The distance for transmitting depends on the
ceiling height. Refer to the table below about the distance.
The distance may di󰀨er depending on the building structure.
Control the wireless remote control switch within the distance
shown in the table below.
• The distance for transmitting will get shorter due to battery
consumption. In this case, replace the battery.
(
)
The distance for transmitting di󰀨ers depending on the
ceiling height. Refer to the table below about the detail.
Capable distance
for transmitting
maximum 6m
Wireless remote
control switch
Direst line between
transmitter and receiver
Receiver kit
(Receiver part)
9.11 HORINZONTAL DISTANCE LIMIT FOR RECEIVER KIT
Horizontal distance limit for receiver kit (in the case that height of
wireless remote control from oor is 1 m):
Ceiling height (m) 2.5 2.7 3.0 3.5
Horizontal distance (m) 2.7 2.9 3.5 4.0
1m
Ceiling
Indoor unit (air panel)
Receiver Kit
(Model: PC-ALHC1)
Ceiling height
Floor
Horizontal distance
Wireless remote
control switch
AIR PANEL P-AP56NAMR
PMML0570 rev.0 - 01/2021
20