1. High pressure switch.
2. Pressure switch for control.
3. Brazing.
¿ Removing four-way valve coil
1 Remove the pipe cover following Removing pipe cover, see on page 395.
2 Remove three (3) fixing screws and remove the upper cover.
3 Remove the front cover following Removing front cover, see on page 395.
4 Remove the electrical box cover.
5 Disconnect the PCN6 connector on the control PCB of the electrical box.
1: PCN6 Connector (Green)
6 Remove one (1) fixing screw to remove the 4-way valve coil.
1. 4-way valve.
2. 4-way valve coil.
3. Screw.
N O T E
• DO NOT touch electrical components while the LED1 (Red)
is ON to avoid electrical shock. Wait until the LED turns off.
¿ Removing electronic expansion valve coil
1 Remove the pipe cover following Removing pipe cover, see on page 395.
2 Remove three (3) fixing screws and remove the upper cover.
3 Remove the front cover following Removing front cover, see on page 395.
4 Remove the electrical box cover.
5 Remove seven (7) fixing screws and remove the side cover.
To Next Page
Loading...
