2-69
SERVICING
(2.5 2-Way Cassette Type)
Phillips Screwdriver, SpannerTool
(4) Remove the fan runner and the fan motor.
Remove the fan runner after removing the cap nut and the washer fixing the fan runner.
(a) Disconnect the earth wire for the fan motor.
(b) Remove four (4) nuts fixing the fan motor and remove the fan motor.
(When reassembling, the required tightening torque for the cap nut is approximately
8N-m (80kg-cm).
* Q’ty of Fan Runner and Fan Motor: Each 1 (RCD-1.0 to 3.0FSG1)
Each 2 (RCD-4.0 to 5.0FSG1)
TURN OFF all power source switches.
Nut
Fan Motor
Earth
Runner
Flat Washer
Cap Nut
To Next Page
Loading...
