Hitachi UTOPIA RAS-4HVRP2E - Ras-(4-6)H(V)(R;N)(C;P)2 E; Remove Outlet Grille; Removing Service Cover; Removing Upper Cover

9 Servicing
RAS-(4-6)H(V)(R/N)(C/P)2E
SMGB0136 rev.0 - 07/2021
184
9.3 RAS-(4-6)H(V)(R/N)(C/P)2E
9.3.1 Removing service cover
NOTE
• Followtheprocedurebelowtoremovemainpartsandcomponents.Formountingfollowthereverseprocedureofremoval.
• Donotexposetherefrigerantcycletotheatmosphereforalongperiodtoavoidmoistureordustenteringintothecycle.Besureto
replacepartsimmediatelyafterremoving.Sealtherefrigerantcyclewhenleftunattachedforalongperiod.
1 Pull downward and remove the service cover after removing 4
upper and lower xing screws.
• Pay attention not to drop the service cover.
Service Cover
1
1 Service cover
9.3.2 Remove outlet grille
1 Remove 4 screws which x the outlet grille.
Service Cover
A
ir Outlet Grille
Shroud
1
2
3
1 Service cover
2
Air outlet grille
3
Shroud
9.3.3 Removing upper cover
1 Remove the upper cover upward after removing 11 xing screws.
Upper Cover
1
1 Upper cover