Hitachi UTOPIA RAS-4HVRP2E - Optional Parts and Installation RAS-(4-6)H(V)(R;N)(C;P)2 E; Air Flow Guide AG-335 A

2 Optional parts and installation
Optional parts and installation RAS-(4-6)H(V)(R/N)(C/P)2E
SMGB0136 rev.0 - 07/2021
34
2.2 Optional parts and installation RAS-(4-6)H(V)(R/N)(C/P)2E

Air ow guide wind guard and snow protection hood
Optional parts Model
Air ow guide AG-335A
1
3
2
1 Air ow guide
2 Wind Guard
3 Snow protection hood
Wind guard WSP-335A
Snow protection
hood
Zinc plate
Air outlet
ASG-NP335F1 (Half)
ASG-SP11FB (Full)
Air inlet of rear side ASG-SP10BE
Air inlet of side face ASG-SP10LE
Stainless plate
(SUS304)
Air outlet
ASG-NP335FS4 (Half)
ASG-SP11FBS2
Air inlet of rear side ASG-SP10BES2
Air inlet of side face ASG-SP10LES2
Drain Heater DH-SP280A
2.2.1 Air ow guide AG-335A

Specications
Air discharge direction Upward (downward) left and right
Material Weather proof polypropylene resin
Color Natural gray
Weight 1.9 kg
Accessories
Fixing screw 4 x [M5 (SUS) x 20]
Installation manual
Installation restriction
“Wind guard” or “Snow protection hood” is not
available to install with air ow guide.

Installation
1 To attach the air ow guide, remove the 4 xing screws at corner of resin air outlet grille.
Then, attach the air ow guide by 4 screws (accessory). (Tightening torque: 2.4 - 3.1Nm)
2 When the air ow guide is attached, do not remove the air outlet grille.
(If it is removed, there is danger of touching fan rotating parts.)
? NOTE
Air ow direction of both air ow guides should be the same.

One air ow installation
Screw (4 x M5)
(Accessory)
Air ow
Air outlet grille
Air ow guide