Hitachi UTOPIA RAS-4HVRP2E - Page 202

9 Servicing
RAS-(4-6)H(V)(R/N)(C/P)2E
SMGB0136 rev.0 - 07/2021
200

Disassembly / Assembly the Inverter module (PCB1)
1 Disassembly the upper cover according to the item “9.3.3Removinguppercover”.
2 Open the electrical box according to the item “Opening/ClosingElectricalbox(Pplate)”.
3 Disconnect all the wiring connected to the control PCB.
4 Remove the 4 xing screws -1-.
5 Remove the 4 xing holders -2- and disassembly the control PCB.
6 Assembly the new control PCB and x it with 4 xing holders -2-.
7 Assembly the 4 xing screws -1-.
1
2
8 Connect all the wiring connected to the control PCB as it was originally.
9 Close the electrical box according to the item “Opening/ClosingElectricalbox(Pplate)”.
10 Assembly the upper cover according to the item “9.3.3Removinguppercover”.

Disassembly / Assembly the DSW module (PCB2)
1 Disassembly the service cover according to the item “9.3.1Removingservicecover”.
2 Disconnect all the wiring connected to the control PCB.
3 Remove the 4 xing holders -2- and disassembly the control PCB2 -1-.
4 Assembly the new control PCB -1- and x it with 4 holders -2-.
2
1
5 Connect all the wiring connected to the control PCB as it was originally.
6 Assembly the service cover according to the item “9.3.1Removingservicecover”.