User manual C4 – C6
91
8. TRANSPORT, STORAGE, DISPOSAL
8.1. Transport
8.1.1. General
Only use suitable lifting accessories with the correct
capacity for the lifting application. The lifting
accessories must be accompanied by a certificate,
have a periodic inspection, be visually inspected and
have been found to be suitable for use.
Drive the C4 compact crane forwards onto a trailer
and backwards off of it. For the C6 compact crane
either direction is permitted.
The clearance angle of the loading ramps must not
exceed 15 degrees.
When transporting the compact crane, make sure the
crane is in transport mode and that any load is
removed: no load on the hook, outriggers stowed and
secured and boom retracted.
Make sure the outriggers are fully retracted and locked in position and that the crane is fully
collapsed.
There must not be any load on the compact crane.
Use loading ramps of sufficient size and capacity. The loading ramps must be long enough so
that the angle with the ground is less than 15°.
Drive the machine forwards onto a means of transport intended for this purpose in the way
described in section 6.4; when driving the machine up the ramps the operator must be assisted
by a person who provides instructions concerning the driving direction.
Stop the motor/engine as described in section 6.4.
Set the switch on the electrical cabinet to position '0'.
Remove any loose parts from the machine.
To Next Page
Loading...