11. Maintenance Procedures
98
To shut down the tractor:
Preserving engine
This procedure provides instructions on how to preserve the engine.
Before preserving the engine:
1. Read and follow the manufacture's instructions for the corrosion-protection oil to be used for
preserving engine.
To preserve the engine:
Danger of chemical burns
Wear suitable personal protective equipment when handling fluids and lubricants (safety clothing, safety
goggles, safety gloves).
Immediately change soaked clothing and shoes.
After eye contact, rinse thoroughly (at least 10 minutes) with clear water and immediately see an
ophthalmologist. In case of intensive skin contact with the substances, wash them off with soap and
water.
If you disregard these guidelines, there is a possibility of severe or fatal injuries.
Danger of poisoning
Risk of slipping
1. Clean the engine (how?).
2. Run the engine to operating temperature.
3. Drain engine oil (all?) and fill (what to fill?)with corrosion-protection oil (what kind?).
4. Drain some (how much?)fuel and fill the fuel tank with corrosion-protection oil at the ratio of
90% of diesel fuel to 10 % of corrosion-protection.
5. Let the engine run for 10 min.
6. Shut off the engine.
7. Turn the engine over several times by hand (?)
8. Plug intake opening and exhaust opening (plug where?)
Removing hydraulic oil
This procedure provides instructions on how to remove hydraulic oil.
Risk of slipping
To Next Page
Loading...