9. Getting ready to work with attachments
82
Figure_C 992_04
The delivery flow from flow dividers I and II can be combined with the connection line*. This then
yields a delivery flow of 0-50 l/min.
Procedure
1. Set the changeover lever (1) in the articulation area so it points downward.
The flow dividers I and II are now connected.
2. Set the rotary knob for flow divider II to the maximum position.
Set the desired delivery flow with the rotary knob of flow divider I.
3. Set changeover lever (1) so that it points to
Risk of accident from improper operation of attachments
Adjust the delivery flow to the power requirement of the attachment. An excessively large delivery flow
can lead to damage of the tractor and the attachment. This can cause hydraulic lines to burst and injure
bystanders. If you disregard these guidelines, there
the left.
Flow dividers I and II are now again disconnected.
* Optional equipment
Operating flow divider I
Risk of accident from improper operation of attachments
Adjust the delivery flow to the power requirement of the attachment. An excessively large delivery flow
can lead to damage of the tractor and the attachment. This can cause hydraulic lines to burst and injure
bystanders. If you disregard these guidelines, there is a possibility of severe or fatal injuries and damage
to the attachment or the tractor.
ADVICE
Operating the flow divider* properly
Activate flow divider (2) only at a low engine speed. Slowly increase the speed of the engine after
operating the switch.
If you disregard these guidelines, there is a possibility of damage to the tractor.
To Next Page
Loading...