9. Getting ready to work with attachments
78
A relief pressure below 30 bar (lightweight devices) leads to frequent control processes, since the
accumulator cannot act yet.
This control sensitivity sets the characteristics of the implement relief.
1. Push the mode button twice within three seconds. HYS1 appears in the display; the current value
(?) flashes after two seconds.
2. Use the button (name?) to reduce the current ? value.
3. Use the button (name?) to increase the current value.
Note: To switch off implement relief, push the button (24 name?) on the keypad and ensure
that the light in the button turns off.
Operating tipping system
Tipping framework can fall down
Working under the raised tipping framework is permitted only with additional support put into place.
When working with attachments, always ensure that they are secured to the tipping framework.
The tipping framework can unintentionally fall down.
If you disregard these guidelines,
Procedure
there is a possibility of severe or fatal injuries and damage to the tractor.
WARNING
Warning against improper use of the tractor
Prevent persons from being present in the danger zone of the rear end and the attachments when the
hydraulic equipment is in operation.
If you disregard these guidelines, there is a possibility of severe injuries.
Lowering
1. Push button (1) and push the joystick (10) forward at the same time. The tipping device* is lowered
proportionally. Guide joystick (10) back into the center position; lowering stops.
Operating floating position
DANGER
Risk of accident from improper usage of the tractor
Never stand underneath attachments or tipping systems.
To Next Page
Loading...