9. Getting ready to work with attachments
83
The flow divider I* is used for driving a hydraulic motor in a device such as a salt spreader, hedge cutter
or the like with a variable power requirement. The working speed of the attachment can be adjusted
independently of the tractor's engine speed. The flow divider is fed by the hydraulic pump and operated
from the driver's seat.
Procedure
1. Connect the hydraulic hoses of the attachment to the red hydraulic couplings for drive
(1) and return (2) at the front of the tractor.
2. Switch on master switch (11) for working hydraulics.
3. Lamp in the switch (31) and LED display singly-acting hydraulic function in button (31) is lit.
4. Adjust the speed of the engine with the fine adjustment control to the desired rotational speed.
5. Use the dial switch (30) to set the working speed required for the attachment.
– Turn clockwise = speed is increased
– Turn anti-clockwise = speed is reduced
– The hydraulic motor in the attachment is supplied by an oil flow of 0-25 l/min.
6. Briefly press key (31) to switch off the flow divider. LED-indicator goes out
7. Switch off master switch (11) for the working hydraulics.
* Optional equipment
Operating flow divider II
Risk of accident from improper operation of attachments
Adjust the delivery flow to the power requirement of the attachment. An excessively large delivery flow
can lead to damage of the tractor and the attachment. This can cause hydraulic lines to burst and injure
bystanders. If you disregard these guidelines, there is a possibility of severe or fatal injuries and damage
to the attachment or the tractor.
Operating the flow divider* properly
Activate flow divider (2) only at a low engine speed. Slowly increase the speed of the engine after
operating the switch.
If you disregard these guidelines, there is a possibility of damage to the tractor.
To Next Page
Loading...