9. Getting ready to work with attachments
73
10 The set volume current limit refers to
the max. joystick movement. You can save several joystick functions.
Procedure storage
1. Switch on master switch (11) for working hydraulics.
2. Push joystick (10) without any button or select a joystick function (1-4) with which the working
speed is to be changed.
3. Move joystick (10) to the corresponding level until the desired working seed is reached and hold it
there.
4. At the same time, push the button (24).
Working speed for this joystick function is saved.
Select other joystick functions and save them accordingly.
Procedure for deletion
1. Push joystick (10) without any button or select a joystick function (1-4) with which the working
speed is to be changed.
2. Move the joystick (10) in the corresponding level to the end and hold it there.
3. At the same time, push the button (24).
Working speed for this joystick function is saved.
Select other joystick functions and save them accordingly.
Switching functions
Switching functions
3 Use the button (27) to switch an additional function to the button
(3) at the joystick or
(4) at the multifunctional joystick.
10 These functions can be specified by your Holder service partner.
Possible functions on the button (3 joystick, 4 multifunction joystick)
S1090_074
1. Float switch tail lift (standard)
2. Floating position for green hydraulic coupling
To Next Page
Loading...