Honeywell 6824 User Manual

Chapter 1 – About the Printer
8 6824 Mobile Full Page Printer User Manual
Internal temperature error READY: On
FAULT: Blinking every half second
TRACTOR: Off
Internal printer temperature is too hot or too cold
(less than -40 °C or more than 150 °C). To
recover, turn off the printer.
Printhead jam or carrier
error
READY: Blinking every half second
FAULT: Blinking every half second
TRACTOR: On
Either the printhead cannot find the home
position when you turn on the printer, or the
printhead reaches the home position
unexpectedly. To recover, turn off the printer.
System error READY: Blinking every half second
FAULT: Blinking every half second
TRACTOR: Off
An illegal printer logic condition was detected. To
recover, turn off the printer.
EEPROM error READY: On
FAULT: Blinking every half second
TRACTOR: Blinking every half
second
An EEPROM checksum error was detected. To
recover, turn off the printer.
RAM error READY: Off
FAULT: Blinking every half second
TRACTOR: Blinking every half
second
RAM read/write check failed. To recover, turn off
the printer.
Font error READY: Blinking every half second
FAULT: Blinking every half second
TRACTOR: Blinking every half
second
Font check code error was detected. The printer
indicators show this error state for 7 seconds,
and then the printer enters initial program
loading mode. In this mode, the printer will not
function normally.
For more information, see “Recover From a Font
Error.”
Error State Descriptions (continued)
Error Type Indicator Behavior Description and Recovery

Honeywell 6824 Specifications

General

Brand	Honeywell
Model	6824
Category	Printer
Language	English