Chapter 3 – Configure the Printer
42 6824 Mobile Full Page Printer User Manual
Upload Fonts or Firmware With the Configuration
Utility
To upload fonts or firmware to the printer, you use the Printer Configuration
Utility.
• Firmware files can be downloaded from honeywellaidc.com.
• For more information on obtaining fonts, contact Honeywell Technical
Support.
To use the Configuration Utility, you need a Bluetooth connection between your
PC and the printer.
Two-Part Carbon-Interleaved Media
Parts Spec (g/m2)
Layer Thickness
(Min–Max, in mm)
Total Thickness
(Min–Max, in mm)
Gap Setting
Top 40 to 64 .051 to .082 .133 to .216 1.2 or 2.0
Carbon One sheet .030
Bottom 40 to 81 .051 to .104
Three-Part Carbon-Interleaved Media
Parts Spec (g/m2)
Layer Thickness
(Min–Max, in mm)
Total Thickness
(Min–Max, in mm)
Gap Setting
Top 40 to 64 .051 to .082 .214 to .329 2.2 or 3.0
Carbon One sheet .030
Middle 40 to 64 .051 to .082
Carbon One sheet .030
Bottom 40 to 81 .051 to .104
Caution: Do not disconnect or turn off the printer while files are being uploaded.
To Next Page
Loading...
Need help?
General