Chapter 3 – Configure the Printer
34 6824 Mobile Full Page Printer User Manual
Advanced Settings
This section lists advanced settings for the printer. To view these settings, in the
Printer Configuration Utility click the Advanced Settings tab.
Int’l Character Set Selects the national character set:
• USA
• FRANCE
• GERMANY
• ENGLAND (UK)
• DENMARK I
• SWEDEN
• ITALY
• SPAIN I
• JAPAN
• NORWAY
• DENMARK II
• SPAIN II
• LATIN AMERICA
• HEBREW
• GREECE
USA
Zero Option Sets whether the zero character prints with or without a slash. NO SLASH
CR Code Sets whether or not ‘CR’ performs a line feed in addition to a
carriage return.
CR = CR (carriage
return only)
LF Code Sets whether or not ‘LF’ performs a carriage return in addition
to a line feed.
LF = LF (line feed only)
Idle to Sleep Sets the method for the inactivity sleep timer:
• FOLLOW ESC z: Timer is set by the ESC “z” command.
Default is 10 seconds.
• 1 MINUTE ... 4 HOURS: Printer goes to sleep mode after
idling for the specified time.
5 MINUTES
General Settings (continued)
Setting Description Default
Advanced Settings
Setting Description Default
Horizontal Pitch Sets horizontal pitch:
• 10 CPI: 10 characters per inch. Corresponds to ESC “P”, Select
Pica Pitch.
• 12 CPI: 12 characters per inch. Corresponds to ESC “M”,
Select Elite Pitch.
10 CPI
Vertical Pitch Sets vertical pitch:
• 1 to 12 LPI: Specified in lines per inch.
• 1 to 4 LPCM: Specified in lines per centimeter.
6 LPI