Appendix A – Specifications and Command Lists
52 6824 Mobile Full Page Printer User Manual
Media Specifications
The printer works with 1-3 ply carbonless paper that is single-edge glued and
designed for sprocket feed. Standard paper size is 8.5 x 11 inches or 241 x 305
mm international (8.5 x 12 in). Use 3-ply forms up to a maximum of 0.23 mm
(0.009 in) thick.
A soft, flexible, rubber type cement applied to one perforation strip only is
preferred. The paper should wrap around a 1 1/4 in diameter roll without curl or
wrinkle.
Material Breakdown
This section includes information on supported fanfold media for the printer.
Parity None
Bit Rate 19.2 K
Caution: Using paper that matches the following specifications ensures
optimum performance. Variation from these specifications, use of aged paper, or
use of paper exposed to elements such as dirt or humidity may cause printing
problems.
Factory Default Settings (continued)
Setting Default
14# CBF (Carbonless Back and Front)
Target (lb) Under (lb) Over (lb)
Basis Weight 14 13.3 14.7
Caliper 2.9 2.6 3.2
Moisture 5.0 4.0 6.0
Smoothness (RS) 165 110 230
Smoothness (CB) 270 220 320
Brightness (Wht) 88 86 90
15# CBF (Carbonless Front)
Target (lb) Under (lb) Over (lb)
Basis Weight 15 14.43 15.8
Caliper 3.0 2.5 3.2
Moisture 5.0 4.0 6.0
Smoothness (RS) 140 100 180
Smoothness (CB) 140 100 180
Brightness (Wht) 85 84 86
To Next Page
Loading...
