Appendix A – Specifications and Command Lists
56 6824 Mobile Full Page Printer User Manual
ESC “A” n Select n/72-inch line spacing
ESC “B” NUL Clear vertical tabs
ESC “B” n1 n2 ... nk NUL Set vertical tabs
ESC “C” n Set page length (lines)
ESC “C” NUL n Set page length (inches)
ESC “D” NUL Clear horizontal tabs
ESC “D” n1 n2 ... nk NUL Set horizontal tabs
ESC “E” Select emphasized mode
ESC “F” Cancel emphasized mode
ESC “G” Select double-strike mode
ESC “H” Cancel double-strike mode
ESC “I” n Expand printable code area
ESC “J” n Perform n/216-inch line feed
ESC “K” n1 n2 Select single-density graphics mode
ESC “L” n1 n2 Select low-speed double-density graphics mode
ESC “M” Select elite pitch
ESC “N” n Set skip over perforation
ESC “O” Cancel skip over perforation
ESC “P” Select pica pitch
ESC “Q” n Set right margin
ESC “R” n0 n1 n2 Code page selection
ESC “R” n Select national character set
ESC “S” 0* Select superscript mode
ESC “S” 1* Select subscript mode
ESC “T” Cancel subscript/superscript mode
ESC “U” 0* Cancel unidirectional printing
ESC “U” 1* Select unidirectional printing
ESC “W” 0* Cancel double-wide mode
ESC “W” 1* Select double-wide mode
ESC “Y” n1 n2 Select high-speed double-density graphics mode
ESC “Z” n1 n2 Select low-speed quadruple-density graphics mode
ESC “^” (0) n1 n2 Select 9-pin single-density graphics mode
ESC “^” (1) n1 n2 Select 9-pin double-density graphics mode
ESC “b” c NUL Clear vertical tab channel
ESC “b” c n1 n2 ... nk NUL Set vertical tabs in channel
ESC “j” n Perform n/216-inch reverse line feed
ESC “l” n Set left margin
ESC “s” 0* Cancel half-speed printing
ESC “s” 1* Select half-speed printing
ESC “t” (0) Disable printing of character graphics
Escape Sequences and Descriptions (continued)
ESC Description
To Next Page
Loading...
