EAGLEHAWK NX CONTROLLER EVERYDAY OPERATIONS
45 EN2Z-1053GE51 R0119
Purpose View any actual points in alarm
Procedure
1. In the HOME screen, turn the rotate&push button to navigate to and highlight
Alarm List
.
1. Push the rotate&push button.
The Alarms menu is displayed. The Points in Alarm submenu is
highlighted.
2. Push the rotate&push button.
The Points in Alarm screen is displayed. All datapoints that are currently in
alarm, are displayed.
Depending on its current alarm status, a datapoint shows any of the following
visual status indicators:
Icon Function
Datapoint is in "overridden status"
(manual mode)
Datapoint is in "Out of Service status"
Datapoint is in "Alarm status"
Datapoint is in alarm status "fault"
Datapoint is in alarm status "normal" and
alarm is not acknowledged
Datapoint is in alarm status "off-normal"
and alarm is not acknowledged
Datapoint is in alarm and alarm is
acknowledged
NOTE: Multiple statuses can be indicated.
To get information on the meaning of a status indicator, you can also press
he Help soft key.
3. Depending on the current operating mode (auto, manu), an alarm datapoint
can be set into the opposite operating mode (manual, or auto). For setting a
datapoint into manu mode, please refer to the "Setting Datapoint into Manual
Mode" section, p. 49.
4. To set a datapoint into auto mode, turn the rotate&push button to navigate to
and highlight the data point.
5. Then, push the rotate&push button.
To Next Page
Loading...
