EVERYDAY OPERATIONS EAGLEHAWK NX CONTROLLER
EN2Z-1053GE51 R0119 50
5. To scroll through the list, turn the rotate&push button.
6. Navigate to and highlight the datapoint you want to put into manual mode.
7. Push the rotate&push button. The datapoint status is displayed.
8. Push the rotate&push button.
The Manual checkbox will be enabled.
9. Turn the rotate&push button to navigate to and highlight the value.
10. Change the value as described in the "Adjusting and Saving Values and
Options" section, p. 19.
11. Turn the rotate&push button to navigate to and highlight OK.
12. The Station Point List screen redisplays. The datapoint is in manual mode as
indicated by the Manual command symbol
.
Settings
Settings include the following functions:
Setting date, time and time zone
Setting the watchdog
Setting the station auto save time
For … … refer to the following sections and subsections … on page
Setting date, time and time zone
Setting Date, Time
and Time Zone
51
Setting the watchdog Setting Watchdog 53
To Next Page
Loading...
