EAGLEHAWK NX CONTROLLER EVERYDAY OPERATIONS
47 EN2Z-1053GE51 R0119
Depending on their current alarm status, datapoints show any of the following
visual status indicators:
Icon Function
Datapoint is in "overridden status"
(manual mode)
Datapoint is in "Out of Service status"
Datapoint is in "Alarm status"
Datapoint is in alarm status "fault"
Datapoint is in alarm status "normal" and
alarm is not acknowledged
Datapoint is in alarm status "off-normal"
and alarm is not acknowledged
Datapoint is in alarm and alarm is
acknowledged
NOTE: Multiple statuses can be indicated
You can select an alarm for viewing its details and acknowledging it if
acknowledgement is required.
5. To do so, turn the rotate&push button to navigate to and highlight the data
point.
6. Then, push the rotate&push button.
The details of the alarm are displayed. Details include the following:
– alarm text time stamp
– alarm source
– time stamp
– notes
– from state to state
– category
7. Scroll through the list to view all details by turning the rotate&push button.
8. To acknowledge an alarm, at the bottom of the Alarm Details screen,
highlight the Acknowledge command, then push the rotate&push button.
The alarm is acknowledged and removed from the alarm counter. The Alarm
List screen redisplays.
Datapoints
Datapoints can be operated by doing any of the following actions:
Viewing Datapoints in Manual Mode
Setting Datapoints into Manual Mode
Changing Datapoint Values
To Next Page
Loading...
