BASIC OPERATION PROCEDURES EAGLEHAWK NX CONTROLLER
EN2Z-1053GE51 R0119 26
Saving Settings
Current settings displayed in the screen will be saved by using the OK command.
Turn the rotate&push button to navigate to and highlight the OK command at the
bottom of the screen.
Push the rotate&push button.
NOTE: In some screens, initially the OK command is not visible. Scroll
through the screen until the command will be accessible at the bottom.
Canceling Changed Settings
To discard currently changed settings displayed in a screen, do any of the following:
Back command
Turn the rotate&push button to navigate to and highlight the Back command at
the bottom of the screen.
Push the rotate&push button.
All inputs already done will be discarded.
Back operating key
At any point during operation when settings are not confirmed by using the OK
command, pressing the Back operating key discards any changes.
Working with Command Symbols and Soft keys
At certain spots in the operating sequence, special command symbols are available.
The corresponding commands are executed by pressing the corresponding
operating key (soft key) to the immediate right on the housing.
Example Editing an Entry
To Next Page
Loading...
