Honeywell CentraLine EAGLEHAWK NX - Viewing Datapoints in Manual Mode

EVERYDAY OPERATIONS EAGLEHAWK NX CONTROLLER
EN2Z-1053GE51 R0119 48
For … … refer to the following sections and subsections … on page
Viewing Datapoints in Manual Mode Datapoints – Viewing Datapoints in Manual Mode 48
Setting Datapoints into Manual Mode Datapoints – Setting Datapoints into Manual Mode 49
Changing Datapoint Values Datapoints – Setting Datapoints into Manual Mode 49
see also
Viewing Datapoints in Alarm Alarm List – Viewing Datapoints in Alarm 44
Viewing Datapoints in Manual Mode
Purpose Shows the list of datapoints which are currently in manual mode.
Procedure
1. In the HOME screen, turn the rotate&push button to navigate to and highlight
the General menu icon
.
2.
3. Then push the rotate&push button. The General menu is displayed.
4. Turn the rotate&push button to navigate to and highlight Points in Manual.
5. Push the rotate&push button.
All datapoints that are currently in manual mode are displayed. The manual
mode is indicated by the Manual command symbol
.
A datapoint can be set into automatic mode as described in the following.
6. To set a datapoint into automatic mode, turn the rotate&push button to
navigate to and highlight the datapoint.