Honeywell Enraf 1010 CB - Transaction Number; Clock

System (2)
4 - 7 Model 1010 Application Pack CB Part No.: 4418024 - Rev. 1
Programming Manual
 NET
4.2.6 Transaction Number
Transaction Number Allows the operator to key in the current transaction number to ensure
continuity of operation after the instrument has been reset. The next
transaction will use this value + 1.
Enter a value in the following range:
 0 to 9999999 (0*)
Overwrite Oldest Trans Allows to enable the feature of overwriting the last transaction.
Select one of the following options:
 Enable
 Disable*
4.2.7 Clock
Use the Clock sub-menu to set the instrument clock.
NOTE: The internal clock is used for transaction time and date stamping
Year Sets the year on the internal clock.
Enter a value in the following range:
 2009 to 2108
Month Sets the month on the internal clock.
Enter a value in the following range:
 1 to 12
Day Sets the day on the internal clock.
Enter a value in the following range:
 1 to 28/29/30/31
Hour Sets the hour on the internal clock in 24-hour format. For example,
4:30 p.m. is 16:30, therefore you would enter ‘16’.
Enter a value in the following range:
 0 to 23
Minutes Sets the minutes on the internal clock.
Enter a value in the following range:
 0 to 59
Display Date Format Sets the date format for service display.
Select one of the following options: