1 - 1 Model 1010 Application Pack CB Part No.: 4418024 - Rev. 1
Programming Manual
CHAPTER 1 OVERVIEW
1.1 Description
This manual describes the setup procedures for the Model 1010 loading
system.
It is intended for managers or supervisors who may be required to do
the following:
Change the setup parameters
Program personnel and/or vehicle ID numbers for authorisation
purposes.
1.2 Terminology and Conventions
In this document, “instrument” refers to the generic Model 1010 loading
system, and “computer” refers to the attached computer, Distributed
Control System (DCS), Load Rack Computers (LRC), or Terminal
Automation System (TAS).
Litres and Litres/Minute are used as the default units throughout this
manual. When other units are programmed in the instrument (such as
Gallons), the units in other programmable and displayed parameters
change accordingly.
An asterisk (*) denotes default options.
To Next Page
Loading...
