Honeywell Enraf 1010 CB - Name; Setup

Loading Arms (3)
5 - 2 Model 1010 Application Pack CB Part No.: 4418024 - Rev. 1
Programming Manual
5.2.2 Name
Use the NAME sub-menu for entering an arm name.
Select Arm Name Use to select the type of arm name to be displayed for this arm.
Select one of the following options:
 DEFAULT* (ARM n)
 EDIT
 ULP
 PULP
 AVGAS
 ADF
Edit Arm Name If enabled allows an 8 character alphanumeric description to be entered
for the arm, for example “ULP”, “Diesel”, “Kero”.
Constraints: Select Arm Name = EDIT
 8 character alphanumeric
Edit HM Classification Use to select the HM classification number.
Enter a value in the following range:
 1 to 3500 (1*)
5.2.3 Setup
Use the Setup sub-menu to enable or disable an arm, select the display
unit for an arm, select between mass or volume based preset, or set the
maximum preset for an arm.
Enable Arm n If enabled, the arm is available for use.
If disabled, the arm will not be available for use. This is typically used
when a particular arm should not be used, for example, when a pump
fails or a tank is empty.
Constraints: Only available when you use the Weights and Measures
switch on the instrument to enter Programming mode.
Select one of the following options:
 Enable*
 Disable
Units Selects the Metric - ISO units that are displayed for the particular arm.
Constraints:
 Only if Units under General Setup (21) = Metric - ISO Units.
 Only available when you use the Weights and Measures switch on
the instrument to enter Programming mode.