8 - 1 Model 1010 Application Pack CB Part No.: 4418024 - Rev. 1
Programming Manual
CHAPTER 8 ADDITIVE LINES (6)
8.1 Description
The Additive Lines menu allows the set up of the operating parameters
for the additive injection system in use.
8.2 Configure Additive
Additive Lines (6) Selects the type of additive system from the Additive Line sub-menu.
Select one of the following options:
INTERNAL ADDITIVE LINES
EXTERNAL ADDITIVE LINES
8.3 External Additive Lines (621)
Selects the type of additive system from the Additive Type sub-menu. If
you select INTELLIGENT as the additive type, the instrument displays
the Intelligent Inject Type prompt.
Additive Inject Selects the type of additive injection to use. INTELLIGENT refers to the
EFT Mini-Pak. PULSE OUTPUT refers to the outputs used to provide
additive injector pacing pulses.
Select one of the following options:
None*
EFT Mini-Pak
PULSE OUTPUT
Additive Pulse The additive pulse width in seconds.
ADDITIVE LINES 6
1 - CON
2 - EXTERNAL ADDITIVE LINES
PRESS ENTER TO SELECT
1 - INTERNAL ADDITIVE LINES
ADDITIVE LINES 6
1 - CON
2 - EXTERNAL ADDITIVE LINES
PRESS ENTER TO SELECT
1 - INTERNAL ADDITIVE LINES
To Next Page
Loading...
