Honeywell Enraf 1010 CB - Manager Messages

System (2)
4 - 24 Model 1010 Application Pack CB Part No.: 4418024 - Rev. 1
Programming Manual
Edit Line 2 Use to compose a custom initial message of 20 characters to display on
the bottom line of the screen message area.
Constraints: Only if Initial Message = Custom.
 Bottom Line
20 character alphanumeric message
Selected Permissive Allows each selected permissive to be either enabled or disabled.
Overfill/Ground
Permissive
Allows the Overfill/Ground permissive to be either enabled or disabled.
Constraints: Only if Initial Message = Selected Permissive, if loading
effect of Overfill/Ground is not none.
Select one of the following options:
 Enable*
 Disable
Vapour Recovery Allows the Vapour Recovery permissive to be either enabled or
disabled.
Constraints: Only if Initial Message = Selected Permissive, if loading
effect of Vapour Recovery is not None.
Select one of the following options:
 Enable*
 Disable
Programmable
Permissive
Allows the programmable permissive to be either enabled or disabled.
Constraints: Only if Initial Message = Selected Permissive, if loading
effect of Programmable permissive is not none.
Select one of the following options:
 Enable*
 Disable
4.8.2 Manager Messages
Use the Manager Messages sub-menu to set messages for the
Manager Reset function.
Manager Reset
Message
Selects which message is displayed prior to any loading taking place.
Select one of the following options:
 Standard* (Contact Manager)
 Custom (As entered under edit line)
Contact Manager
Message Edit Line 1
Use to compose a custom message of 20 to display on the top line of
the screen message area.
Constraints: Only if Manager Reset Message = Custom.
 Top Line (20 Character alphanumeric Message)