Honeywell Enraf 1010 CB - Deadman Messages; GP Input Messages

System (2)
4 - 25 Model 1010 Application Pack CB Part No.: 4418024 - Rev. 1
Programming Manual
Manager Reset Message
Edit Line 1
Use to compose a custom message of 20 to display on the top line of
the screen message area.
Constraints: Only if Manager Reset Message = Custom.
 Top Line (20 Character alphanumeric Message)
Manager Reset Message
Edit Line 2
Use to compose a custom message of 20 to display on the bottom line
of the screen message area.
Constraints: Only if Manager Reset Message = Custom.
 Bottom Line (20 Character alphanumeric Message)
Wait for Manager
Message Edit Line 1
Use to compose a custom message of 20 to display on the top line of
the screen message area.
Constraints: Only if Manager Reset Message = Custom.
 Top Line (20 Character alphanumeric Message)
4.8.3 Deadman Messages
Use the Deadman Messages sub-menu to set messages for the
Deadman function.
Constraints: Deadman timer must be enabled.
Deadman Message Select one of the following options:
 Standard* (Deadman Timeout)
 Custom (As entered under Edit Line)
Deadman Timeout
Message Edit Line 1
Use to compose a custom message of 20 to display on the top line of
the screen message area.
Constraints: Only if Deadman Timeout Message = Custom.
 Top Line (20 Character alphanumeric Message)
 Deadman Timer needs to be enabled prior to editing custom
messages
4.8.4 GP Input Messages
Use the GP Input Messages sub-menu to select the input message for
a particular arm or system input. Selection of either the fixed or standard
message is possible for these inputs. Following table lists different