Honeywell Enraf 1010 CB - 8.5 Internal additive Lines (61)

Additive Lines (6)
8 - 3 Model 1010 Application Pack CB Part No.: 4418024 - Rev. 1
Programming Manual
Once an injection point is selected, the following menu, which allows
configuration of different parameters of the injection point, is displayed.
8.5.1 Name/Setup Menu
Enable Injection No n Enables or disables the injection point.
Select one of the following options:
 Enable
 Disable*
Injector No n Assigns an injector number (n) to an arm number. If you do not wish to
assign an additive injector, select NONE. Changing an injector load arm
will erase the arm's recipes.
Constraints: Available only when the injector point is enabled.
Select one of the following options:
 NONE to max available arm number (NONE*)
INTERNAL ADDITIVE LINES 61
- INJECTION POINT 5
- INJECTION POINT 6
- INJECTION POINT 2
- INJECTION POINT 3
PRESS ENTER TO SELECT
- INJECTION POINT 1
INTERNAL ADDITIVE LINES 61
- INJECTION POINT 5
- INJECTION POINT 6
- INJECTION POINT 2
- INJECTION POINT 3
PRESS ENTER TO SELECT
- INJECTION POINT 1
INTERNAL ADDITIVE N 61N
- METER FACTOR
-CON
- ALARM SETUP
- K FACTOR
PRESS ENTER TO SELECT
- NAME/SETUP
INTERNAL ADDITIVE LINES 61
- METER FACTOR
-CON
-
ALARM SETUP
-
K FACTOR
PRESS ENTER TO SELECT
-
NAME/SETUP
INTERNAL ADDITIVE N 61N
- METER FACTOR
-CON
- ALARM SETUP
- K FACTOR
PRESS ENTER TO SELECT
- NAME/SETUP
INTERNAL ADDITIVE LINES 61
- METER FACTOR
-CON
-
ALARM SETUP
-
K FACTOR
PRESS ENTER TO SELECT
-
NAME/SETUP