Honeywell Enraf 1010 CB - Authorisations;Pins

System (2)
4 - 8 Model 1010 Application Pack CB Part No.: 4418024 - Rev. 1
Programming Manual
 DD/MM/YYYY *
 MM/DD/YYYY
 YYYY/MM/DD
NOTE: Slip commands always retain the same date format as laid out in the
Software Protocol Manual regardless of this menu setting.
4.2.8 Authorisations/Pins
Use the Authorisations/Pins sub-menu to set passwords, PINs and
other methods of authorisation access to the instrument.
Setup Password The password required to access any of the parameters in Setup Mode
(4 to 8 digits).
Enter a value in the following range:
 0000 – 99999999 (6789*).
Manager Reset The password required to reset the system after an Emergency Stop or
other system fault. (4 to 8 digits).
Enter a value in the following range:
 0000 – 99999999 (9876*)
PIN Password The password required to enter or edit PIN and touch key numbers
directly within the instrument. (4 to 8 digits).
Select one of the following options:
 0000 – 99999999 (1234*)
Personnel Authorisation Use the Display key to select the type of authorisation that operators will
use to identify themselves to the instrument.
Select one of the following options:
 NONE*
Item Not Displayed
 PIN
Enter personnel PIN > _
 TOUCH
Present personnel touch key
 RF ID
Present personnel RF ID card
 NEXWATCH
Present personnel NexWatch card
Vehicle Authorisation Use the Display key to select the type of authorisation required to
identify the vehicle to the instrument.
Select one of the following options: