Honeywell Enraf 1010 CB - Page 43

System (2)
4 - 27 Model 1010 Application Pack CB Part No.: 4418024 - Rev. 1
Programming Manual
 Overfill/Gnd Messages
 Vapour Rec'y Messages
 Prog Permissive Msg’s
 Emergency Stop Messages
Selected Permissive
Message
Sets the Selected Permissive Message to either standard or custom.
Select one of the following options:
 Standard*
 Custom
Permissive Restart
Message Edit Line 1
A custom restart message of 20 characters may be composed for
display on the top line on the screen message area. The message is
displayed during the loading process if the pemissive is reconnected
within the timeout period.
Constraints: Only if Selected Message = Custom
Not for emergency stop.
This menu is available if loading effect for the selected input is not
NONE.
 Top Line (20 Character alphanumeric Message)
Permissive Connect
Message Edit Line 1
Use to compose a custom initial message of 20 characters to display on
the top line of the screen message area. The instrument displays this
message at the start of the loading process to prompt the operator to
take action to clear the permissive.
Constraints: Only if Selected Message = Custom
This menu is available if loading effect for the selected input is not
NONE.
 Top Line (20 Character alphanumeric Message)
Permissive Connect
Message Edit Line 2
Use to compose a custom initial message of 20 characters to display on
the bottom line of the screen message area. The instrument displays
this message at the start of the loading process to prompt the operator
to take action to clear the permissive.
Constraints: Only if Selected Message = Custom.
This menu is available if loading effect for the selected input is not
NONE.
 Bottom Line (20 Character alphanumeric Message)
Permissive Reconnect
Message Edit Line 1
A custom reconnect message of 20 characters may be composed for
display on the top line on the screen message area. The message is
displayed during the loading process if the permissive become inactive
after the START button is pressed. This message will not appear on the
screen if the loading effect is terminate loading.