Honeywell Enraf 1010 CB - 10.3.2 Erase ID Bank; 10.3.3 Search For an ID

Authorisation Entry Mode
10 - 6 Model 1010 Application Pack CB Part No.: 4418024 - Rev. 1
Programming Manual
1. From the Authorisation menu, select ERASE ID BANK.
The instrument displays the SELECT BANK TYPE prompt.
2. Select one of the following options and then press Enter.
•NONE*
• MASTER
•VEHICLE
• PERSONNEL
•ALL
The instrument displays a message asking for confirmation of the
deletion.
3. Select Yes.
The instrument deletes the selected ID bank and then displays the
SELECT BANK TYPE prompt.
10.3.3 Search For an ID
1. From the Authorisation menu, select SEARCH FOR AN ID.
The instrument displays the SELECT TYPE prompt.
2. Select an option.
The instrument displays ENTER ID ^.
3. Enter an ID number.
• If the instrument finds the ID it displays “ID FOUND AT MASTER
INDEX n”, where ‘n’ is the index number.
• If the instrument cannot locate the ID it displays “ID NOT
FOUND”. After a small delay the menu appears.