Honeywell FUSION - Creating a Preset Tour; Viewing the Preset Tour; Creating a Preset Tour2; Viewing the Preset Tour2

PAN / TILT / ZOOM
7–9
7.5 UNDERSTANDING TOURS, CONTINUED
7.5.1 CREATING A PRESET TOUR
1. Start by creating two or more Preset Positions. (refer to Section 7.4.1)
2. Select the Preset Tour Method. The Preset Tour is now the default Tour method.
3. The Tour is now set to cycle through the defined presets.
7.5.2 VIEWING THE PRESET TOUR
1. From the Main Display Screen, select the PTZ option.
2. Select the PTZ camera of the Tour you just created.
3. Press the Tour Button. The Preset Tour will activate.
7.5.3 CREATING A PRESET TOUR2
1. Start by creating two or more Preset Positions. (refer to Section 7.4.1)
2. Select the Preset Tour2 Tour Method. The Preset Tour is now the default Tour
method.
3. The Tour is now set to cycle through the defined presets at the specified Travel
Speed and Dwell Time defined by the preset tour that is selected in the PTZ setup
menu.
7.5.4 VIEWING THE PRESET TOUR2
1. From the Main Display Screen, select the PTZ option.
2. Select the PTZ camera of the Tour you just created.
3. Press the Tour Button. The Preset Tour2 will activate.