SETUP OPTIONS
5–19
5.6 RECORDING SCHEDULE, CONTINUED
5.6.3 SCHEDULING SENSORS AND RELAYS (BY EXAMPLE)
It is easy to add advanced recording functionality using Sensor Inputs and Relay
Outputs.
SENSOR - Sensor Inputs can be programmed to instantly start one or more cameras
recording when an alarm occurs. These alarm events can also activate Relay Outputs
as desired.
RELAY OUTPUT - Relay Outputs can be set to activate when motion alarms or sensor
alarms occur.
The schedule will be as follows:
1. SUN-SAT (12AM-11:59PM) Cameras 1 and 2 will be activated on Sensor #3
and/or Sensor #5, which will then activate Relay Output #7 and #13.
2. SUN-SAT (12AM-11:59PM) Camera 3 will be set to Record on MOTION.
When motion occurs it will activate Relay Output #7 and #10.
3. SUN-SAT (12AM-11:59PM) Sensor #6 will activate Relay Output #8 when an
alarm occurs. This event will NOT cause any cameras to record.
To do this, a total of 3 schedules will be created.
To Next Page
Loading...
Need help?
General
