REMOTE SOFTWARE
13–5
13.3 SETTING UP THE FUSION REMOTE SOFTWARE, CONTINUED
2. Press New to open the Site Detail Information window.
3. Enter the Site Code and Site Name. The Site Code will be the name displayed
inside the connection box to help identify the unit.
4. Enter the IP Address of the DVR server.
By default the DVR unit is set to connect using DHCP.
5. Enter the Center Port. This setting is specified on the server (See Section 13.2.)
6. Press OK.
7. Click on the newly created connection and enter the login username and
password.
8. Press Connect.
To Next Page
Loading...
