GasAlertMicro 5/PID/IR
User Manual
18
Successful Bump Test: If the bump test passes, the following screens
display.
The detector waits for the sensor(s) to clear (30 seconds) and then
enters normal operation.
Unsuccessful Bump Test: If the bump test is unsuccessful or the bump
test is not performed, the following screen displays and the detector
deactivates.
If additional sensors require a bump test but are not mandatory, the
following screens display.
Press C Yes to accept and proceed to normal operation.
Or
If A No is pressed, or no buttons are pressed, the sensor(s) that is
past due displays as FAIL when the detector enters normal operation.
In the following screen example, only the SO
2
, CO, and O
2
sensors are
operational.
The self-test is now complete.
To Next Page
Loading...
