Honeywell GasAlertMicro 5 - Vol CO 2 (CO 2 Sensors Only); Vol CH 4 (LEL Sensors Only); Correction Factor (CF)

GasAlertMicro 5/PID/IR
User Manual
28
%Vol CO
2
(CO
2
Sensors Only)
Note
Correction factors are not applicable to the CO
2
sensor.
%Vol CH
4
(LEL Sensors Only)
Correction Factor (CF)
Depending upon the selected sensor, refer to the following sections
LEL Sensor
or PID Sensor for more information.
Note
Corrections factors are not applicable to CO
2
sensors.
If the %vol CO
2
is enabled, the detector
displays the carbon dioxide (CO
2
)
readings as %vol (0.0).
From the Sensors option menu, select
CO
2
.
Press H to scroll to %vol CO
2
. Press C
to toggle between enable and disable.
Confirmation is not required. If no buttons
are pushed, after 20 seconds the detector
returns to the sensor selection screen.
The change is saved automatically.
The detector is shipped with %vol CO
2
disabled.
Enable 
Disable 
If %vol CH
4
is enabled, any currently
enabled correction factor is ignored and
the detector operates assuming a
methane (CH
4
) calibration.
From the Sensors menu, select LEL and
press C to confirm.
Next, press H to scroll to %vol CH
4
and
press C within 20 seconds to confirm.
Press C to toggle between enable and
disable.
Confirmation is not required. If no buttons
are pushed within 20 seconds, the
detector returns to the sensor selection
screen. The change is saved
automatically.
The detector is shipped with %vol CH
4
disabled.
Enable 
Disable 