Honeywell GasAlertMicro 5 - Sensor and Lamp Maintenance

75
GasAlertMicro 5/PID/IR
Maintenance
Replacing the Lithium Battery Pack
To replace the lithium battery pack, refer to Figure 14. and the following
steps 1-4.
Figure 14. Replacing the Lithium Battery Pack
1. Open the latch on the bottom of the detector.
2. Remove the battery pack by lifting the bottom of the pack
upward from the detector.
a Warning
Do not disassemble lithium battery packs. Read and
adhere to the cautions in Battery Cautions
.
3. Replace the battery pack with a fully charged lithium
battery pack.
4. Close the latch.
Replacing a Sensor or Sensor Filter
a Warning
To avoid personal injury, only use sensors that are
specifically designed for the detector. Refer to
Specifications
.
Each sensor has a high degree of resistance to common vapors and
gases. To clear a sensor, place the detector in a clean environment
and wait 10 to 30 minutes.
Do not expose a sensor to vapors from organic solvents such as paint
thinners and acetone. For a list of common products that can damage
sensors, refer to Sensor Poisons and Contaminants
.
For sensor problems, refer to Troubleshooting
.