Honeywell GasAlertMicro 5 - Import Datalogs to Fleet Manager II; Minimum PC Requirements; Importing from Microdock II to Fleet Manager II; Import to Fleet Manager II Using a Card Reader

GasAlertMicro 5/PID/IR
User Manual
68
Import Datalogs to Fleet Manager II
Note
Refer to the following minimum requirements before importing
datalogs to Fleet Manager II.
Minimum PC Requirements
• 500 MHz Pentium (or equivalent)
• 100 MB free hard disk space
•Windows XP or Vista
• USB port
Importing from MicroDock II to Fleet Manager II
If the detector is used with the MicroDock II Station to import datalogs to
Fleet Manager II, refer to the MicroDock II User Manual for complete
instructions.
Import to Fleet Manager II Using a Card Reader
To import a datalog file from the detector to Fleet Manager II, complete
the following:
1. Deactivate the detector.
2. Release the latch and remove the battery pack.
3. Remove the MMC/SD card from the detector. Refer to Figure
12. and 1.
4. Connect the card reader to the USB port on the computer.
5. Insert the MMC/SD card into the card reader (ensure the pins
face down).
6. Open Fleet Manager II. Click Start > All Programs > BW
Technologies > Fleet Manager II > BW Technologies Fleet
Manager II.
7. From the top task bar, click Help > User Manual.
8. Refer to section “Importing Data into Fleet Manager II”.