Performance Series IP Camera Software Configuration Guide
8
Select the Maintenance tab from the left pane as shown in Figure 2-6, select target device(s)
and click and the following window is displayed:
Figure 2-8 Firmware Upgrade
The devices were grouped by model. To upgrade the firmware:
1. Select the target device(s) under a model.
2. Click BROWSE and select the upgrade file from your computer.
Figure 2-9 Firmware Upgrade 2
3. Click APPLY. You can check the progress status in the device list.
Accessing the Camera from a Web Browser
next to the IP address of the device as
To access the camera from a web browser, click
shown in Figure 2-6.
Note
The Unified Tool will choose Chrome as default browser to access the camera
webpage firstly. If you haven't installed Chrome, it will run IE instead. When neither
Chrome nor IE is available, it will open Edge to access the camera.
To Next Page
Loading...
