Honeywell H4W2PER2 Series - Figure 5-9 Audio

Performance Series IP Camera Software Configuration Guide
34
Figure 5-9 Audio
To enable audio for the stream, select the Enable check box, select the format (G.711A,
G.711Mu, G.726, AAC), and then select a sampling frequency (8–64 kHz).
In the Conditions area, select the audio input type (LineIn or Mic), enable or disable noise
filtering, and adjust the microphone and/or speaker volumes by moving the sliders. Click the +
and - signs to make fine adjustments. Click Save to apply the settings.