www.honeywell.com/security
66 | Performance Series HQA Digital Video Recorder Remote User Guide
Table 3-14 WEB - Motion Detection Configurations
Configuration Description
Enable Click to enable motion detection. Select a channel from the
drop-down list.
Period Define a period during which motion detection is active.
1. Click Set. The Set configuration interface appears.
2. Click Set after a day of the week to set time periods for that
day.
3. Enter a time range (Period) for when the event detection
area is active, then click the check box to activate that
Period.
Note You can configure up to 6 periods within one day.
4. Click Save.
To Copy Time Periods to Other Days
1. Click Set to select a day with configured time periods.
2. Click the boxes besides the days to select the days to
which to copy the periods.
3. Click Save.
Anti-Dither
Configure a time during which, if another alarm is detected, the
DVR will reset the recording time period/buzzer/tour/PTZ
activation/snapshot but will not reactivate a screen prompt, an
alarm upload, or an email. Choose from
5
to
600
seconds.
Note This anti-dither time does not include the Delay
time.
To Next Page
Loading...
Need help?
General