EasyManuals Logo

Honeywell HRHT4162 Remote User Guide

Honeywell HRHT4162
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #94 background imageLoading...
Page #94 background image
www.honeywell.com/security
94 | Performance Series HQA Digital Video Recorder Remote User Guide
Configuring Network-type ATM/POS Settings
The ATM/POS protocol is required.
There are two Network types: with or without the protocol.
The Source IP is the host IP address that sends out the information (usually this is the IP of the
device host).
The Destination IP is the IP of other systems that receive the information.
With the Protocol
If you are setting up ATM/POS with the protocol, then all you need to do is set the following:
•Source IP
Destination IP (you sometimes need to enter the corresponding port number)
1. Click to select the Network tab.
Figure 3-59 ATM/POS Configuration Interface - With Protocol
2. Select the ATM/POS protocol from the Protocol drop-down menu.
3. Enter a Source IP Address and a Destination IP Address.
4. Click Save.
Without the Protocol
You usually do not need to set the Source Port and Destination Port.
There are a total of four IP groups. The recording channel applies to only one group (optional).
There are 6 ID groups. therefore 6 different types of information about the video can be verified.

Table of Contents

Other manuals for Honeywell HRHT4162

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell HRHT4162 and is the answer not in the manual?

Honeywell HRHT4162 Specifications

General IconGeneral
BrandHoneywell
ModelHRHT4162
CategoryDVR
LanguageEnglish

Related product manuals